Curvo Studio

Transformer and magnetics simulators

Magnetic components move energy and force through flux instead of direct contact. This group has two simulators: the single-phase transformer and the electromechanical relay. In the transformer you can change the turns ratio, the frequency and the load, then read secondary voltage, core flux, losses and efficiency as the 3D model responds. In the relay you can energise the coil and watch the armature pull in, the contacts close and the coil current settle. Both models make an idea that is hard to see on paper very concrete: flux linking two windings, or a small coil current switching a much larger load. The transformer also warns you when a voltage, frequency and turns combination pushes the core into saturation. Start with the transformer to understand ratio and losses, then open the relay to see magnetic force at work.

2 interactive models

TransformerObserve how alternating magnetic flux transfers energy from the primary winding to the secondary winding.Open simulator
New
Electromagnetic relayWatch a small coil current pull an armature onto the core, close a contact that switches a much larger load, and release only after the voltage falls well below the pull-in level.Open simulator

Diagram symbol system: IEC 60617-inspired technical notation